How to back to normal width in Autocad polylines object?

[postlink] http://autocad.mufasu.com/2011/06/how-to-back-to-normal-width-in-autocad.html[/postlink]
[starttext]

AutoCAD Question


When i insert a polyline, i can start drawing a line and then an arc. Up till now, ok. But when i apply the Width or Halfwidth, i only draw 2D-surfaces.

AutoCAD Problem Width on Polyline Object

If i exit and enter the polyline command, then i can only draw 2D surfaces instead of sinlge lines and arcs. How can i turn back to sinlge lines and arcs?

AutoCAD Answer


To get it back to normal:

Command: Pline
Specify start point:
Specify next point or [Arc/Close/Halfwidth/Length/Undo/Width]: w
Specify starting width : 0
Specify ending width : 0

Put starting 0 and ending 0 to back normal line.
[endtext]
Share this article :

Post a Comment

 
Support : Creating Website | Johny Template | Mas Template
Copyright © 2012. AutoCAD Classes - All Rights Reserved
Template Created by Creating Website Published by Mas Template
Proudly powered by Blogger